05
2026-11
Volute Liner and Throatbush Wear Checks Before Replacing Slurry Pump Liners
The volute liner and throatbush protect different parts of a slurry pump's hydraulic passage. The volute liner surrounds the impeller and collects its discharge flow. The throatbush forms part of the stationary suction-side wear region in applicable designs. Inspect them together with the impeller, but replace them according to condition and compatibility rather than an automatic rule that every liner must be changed as a pair.
2026-11-05
05
2026-11
Slurry Pump Impeller Wear and How to Decide When Replacement Is Due
Slurry pump impeller wear becomes a replacement issue when the component reaches its approved condition limit, develops damage that makes continued operation unacceptable, or can no longer support the required duty after other causes have been checked. Appearance alone does not establish the remaining life. Use the wear pattern, component measurements, operating history, and pump performance together before ordering a replacement.
2026-11-05
04
2026-11
Slurry Pump Wetted Parts and the Component Names Buyers Need
Slurry pump wetted parts are the components whose surfaces contact the pumped slurry during normal operation. In a typical lined horizontal centrifugal pump, the principal hydraulic wear parts include the impeller, volute liner, throatbush or inlet liner, and rear liner or frame plate liner insert. Shaft sleeves, seal components, and static seals may also contact process liquid, depending on the arrangement. A bearing assembly normally belongs to the mechanical end, not the slurry passage.
2026-11-04
04
2026-11
High Chrome vs Rubber Lined Slurry Pump Selection for Abrasive Duties
Choose a high chrome or rubber lined slurry pump by checking the solids, liquid chemistry, temperature, and operating conditions together. High chrome is often the stronger candidate when sharp particles, coarse solids, or demanding hydraulic conditions make an elastomer unsuitable. Rubber deserves serious consideration for compatible fine-particle duties where resilience can resist erosion. Neither material wins every slurry application, and concentration alone does not select the liner.
2026-11-04
31
2026-10
How to Read a Pump Curve for Slurry Duty: Derating, Power, and the Shift Away From BEP
A pump performance curve is the single most useful document a slurry pump supplier can hand you, and also the most commonly misread one. On paper it looks simple: a chart with flow rate on the horizontal axis and head on the vertical axis, crossed by curves for efficiency, power, and sometimes the net positive suction head required. In practice, the curve a manufacturer publishes is almost always generated with clean water in a test bay, while the pump you intend to buy will move a mixture of water, solids, and often a corrosive or abrasive chemistry. Reading that curve correctly for slurry duty means knowing exactly which lines still apply, which ones must be shifted, and which axis you are allowed to trust.
2026-10-31
30
2026-10
NPSH in Slurry Service: Calculating NPSHa and NPSHr When the Liquid Isn't Water
Net Positive Suction Head is the margin between the pressure at a pump's suction and the vapor pressure of the liquid it is moving. Get that margin wrong and the pump cavitates: vapor bubbles form on the impeller inlet, collapse a fraction downstream, and pit the metal until the wet end fails. For clean water the calculation is taught in every pump class. For slurry it changes in ways that catch experienced engineers off guard, because the "liquid" is no longer a single-phase fluid and the suction side of a slurry installation is built differently from a water system. This article works through NPSHa and NPSHr specifically for slurry duty — entrained air, suction-line geometry, flooded versus lifted suction, sump design, and the reason a vertical submerged pump often removes the problem entirely.
2026-10-30